Saturday, February 8, 2014
How to Tie a Nerf Bar Netting
Nerf bars are used on race cars, pickups, sports utility vehicles, motorcycles and ATVs. The Nerf bars are usually made from a light to medium weight material such as stainless steel. Nerf bar netting is attached to the bar in a certain way so there is no shifting or moving while you are on or off the road. After attaching the netting, it is imperative that you burn the ends of the nylon netting to make sure it does not fall apart.
Instructions
- 1
Assemble your Nerf bar kit according to the kits instructions. Each manufacturers kit may vary in size, shape and installation instructions.
2Position the Nerf bar netting so the pattern on the net lines up with the net tabs that are on the Nerf bars.
3Grab the end of the netting and push it through the top slot on the net tab. Push the netting through and out the bottom slot.
4Bring the netting up to the middle slot. Push it through the bottom of this slot and back up to the top slot.
5Repeat steps two through four for all the net line ends on your Nerf bar. Adjust the tightness of your netting according to your personal perence.
6Use a scissors to cut the excess ends of your netting. Make sure to leave 1 inch of netting on the ends.
7Hold an end of the netting with needle-nose pliers. Use a lighter to burn the end of the netting. This will prevent the netting from fraying.
8Repeat the previous step for all netting ends.
No comments:
Post a Comment