Thursday, April 3, 2014

How to Reset an Airbag Light on a Honda Odyssey

How to Reset an Airbag Light on a Honda Odyssey

You can reset the airbag light on your Honda Odyssey right from your home garage, saving you time and money. A Honda Odyssey comes with an on-board diagnostics computer that keeps track of all of the vehicles functions. When the Supplemental Restraint System (SRS) light illuminates on the instrument cluster, you need to have the vehicle towed to your mechanic to have it looked at and replaced. Generally, the SRS light only flashes on when the vehicle has been in an accident. If it turns on when there has been no accident, it means the airbag system is malfunctioning and the vehicle should not be driven. But once you have the vehicle fixed, you can reset the light.

Instructions

    1

    Put on safety equipment such as work gloves and goggles.

    2

    Locate the MES connector under the steering column. You can find it next to the fuse box. Pull out the plug in the connector and set aside.

    3

    Use a knife to strip both ends of the coated wire. Touch one end of one wire into one hole on the MES connector and touch one end of the other wire to the other hole in the connector.

    4

    Cross the ends of the wires together to create a short. Although its low voltage, you shouldnt touch the exposed wires.

    5

    Place the key into the ignition and turn it on, but dont allow the engine to turn over while still holding the wires together. Watch as the SRS light blinks on then turns off. Separate the wires right away and the SRS light will turn back on.

    6

    Repeat Step 5 and the SRS light will flash two times and then turn off.

    7

    Shut off the Honda and wait 60 seconds. Start the engine and notice as the SRS light illuminates then shuts off.

No comments:

Post a Comment